CABLE TRAY SUPPORT SYSTEMS
The Cable Tray Support Systems are designed to support cable tray, ducting, and piping at any specified height or width. The support is designed for installation without roof penetrations, flashings, or damage to the roofing material. The supports can be used for virtually any roofing system – from flat roofs to roofs sloped up to 2 in 12. The supports should be spaced according to the specifications.
Seismic and High-Wind applications are available for the system.
Cable Tray Support Systems
|
Cable Tray Support Product Description |
 |
|
Elevated cable tray systems routed across the roof shall be supported off the roof by an engineered prefabricated Walkway System specifically designed to be installed directly on the roof without roof penetrations, flashings, or damage to the roofing material.
For more information, please go to: Design & Quote
|
|
|
Resources |
|
|
| View |
Downloads |
Technical Resources |
PHP Cable Tray Installation
- Layout isolation pads, (provided by contractor), according to the design and layout.
- Place bases on isolation pads.
- Insert legs of duct support into bases and attach with 2-1/2” bolt and 1/2” nut.
- Space out pipe supports according to specifications. This should be done before any weight is supported.
- *Attach horizontal bracing to legs of duct supports, (approximately 3/4” of the way up the height of the support) with 3” bolt and 1/2” nut.
NOTE: If double or triple bracing is required, designated locations will be marked on support legs.
- Adjust width up to bottom of ducting.
- Make sure duct and duct supports are level, both vertically and horizontally, and proper spacing is maintained per design specifications.
- Check that the weight of the ducting is distributed evenly throughout the system.
*Only if bracing is required.
Installation
Photos
Design & Quote
|
2D CAD (211KB)
3D View (2.20MB)
3D PDF
|
Spec Sheet (PDF)
|
|
|
